Navigation

Force and motion

Force and Motion

Set up for drawing input paths

  1. Place the base in portrait position.
  2. Place two rivets up through the base, four holes from the top, one on either side of the base. These will stop the lever from going too far.
  3. Place one rivet in the bottom row of holes, eight holes from the left side.
  4. Place the pre-punched paper over these three rivets.
  5. Place the 0” hole of the strip over the rivet at the bottom of the base. This strip is the lever.
  6. Use a post-it or tape a figure to the end of the strip to mark the output.